Page 1 of 1
What's Wrong Here?
Posted: Sun Mar 12, 2017 9:26 pm
by JBT
Noises again.
Left Rear.JPG
Right Rear.JPG
Re: What's Wrong Here?
Posted: Sun Mar 12, 2017 10:19 pm
by trickytrev
John with out looking at mine is that not a locating guide pin ?
Re: What's Wrong Here?
Posted: Mon Mar 13, 2017 7:56 am
by project.r.racing
That is what happens when bolts are in tight places and they are only finger turn tight and haven't been torqued properly. It is an easy fix. But a fix that shouldn't have to happen.
Re: What's Wrong Here?
Posted: Mon Mar 13, 2017 9:27 am
by JBT
That is what happens when bolts are only finger tight and haven't been torqued at all due to negligence.
Re: What's Wrong Here?
Posted: Mon Mar 13, 2017 9:44 am
by hks_kansei
The top one is clearly wrong, ie missing.
The bottom pic, is that the correct bolt in place even? Or is the NC odd in having some studs up through the body, and some bolts from below?
Re: What's Wrong Here?
Posted: Mon Mar 13, 2017 10:20 am
by JBT
Two studs that feed up through the floor and one bolt into a captive nut.
is that the correct bolt in place even?
Yep, but about to fall out.
Re: What's Wrong Here?
Posted: Wed Mar 15, 2017 3:33 pm
by JBT
So the noise was being caused by a front stabiliser bar link nut that had come loose and now re-torqued. Missing bolt and loose bolt on the rear coilovers replaced/re-torqued.
Noises gone...