Page 1 of 1
NA6 Caliper same as NA8?
Posted: Sun Mar 25, 2007 6:03 pm
by mr_rotary
I am in the process of doing the NA8 front brake upgrade to my NA6. I have read elsewhere when doing the upgrade, only the brake disc is upgraded and they use the existing NA6 brake caliper.
I have a set of NA8 calipers, brackets and discs and have purchased a set of NA8 brake pads to fit the NA8 calipers. This morning I measured it all up and have found the NA8 brake pads easily fit into the NA6 brake calipers!
Is the NA6 caliper the same as the NA8 caliper? Should I swap them over or not?
Posted: Sun Mar 25, 2007 6:27 pm
by StanTheMan
they are the same.
the bracket is for the NA8 is bigger than the NA6 one.
Posted: Sun Mar 25, 2007 7:04 pm
by zoomzoom
Are you sure about that STM? The NA8 has different pads.
Tim
Posted: Sun Mar 25, 2007 7:06 pm
by kula
yup.
the pads and discs are bigger, the new brackets take the calipers futher away from the centre.
Posted: Sun Mar 25, 2007 7:07 pm
by zoomzoom
Scratch my last reply, spoke without even reading it properly
Re:
Posted: Sun Mar 25, 2007 7:18 pm
by mr_rotary
StanTheMan wrote:they are the same.
the bracket is for the NA8 is bigger than the NA6 one.
That's what I thought but I had to ask in case
With upgrading the pads, I do not have the anti-sqeal plates that go on the back of the NA8 pads (NA6 do not fit without bending the pads). I have a parts manual and it seems Mazda do not sell these seperately.
Are they necessary or can I do without them? I am installing Bendix Ultimate pads.
If Mazda do sell them seperately, what is the part No. for an NA8?
Re: NA6 Caliper same as NA8?
Posted: Thu Jan 14, 2016 10:36 am
by BPTravis
so to do a front brake upgrade on my NA6, all i need is the front caliper bracket, pads and discs from an NA8?
Re: NA6 Caliper same as NA8?
Posted: Thu Jan 14, 2016 5:16 pm
by StillIC
Re: NA6 Caliper same as NA8?
Posted: Fri Jan 15, 2016 4:58 pm
by slomo
The NA6 calipers fit the na8 brackets and as noted by others this moves the caliper further (10mm) from the centre of the hub thus allowing fitment of the larger NA8 rotors. The NA8 bracket also holds the larger NA8 pads. I believe this upgrade is a safety essential for all NA6s. I've done this very upgrade twice.
I hope this clarifies topic.